QTY
$22900
VideoMic Pro with Rycote Lyre Suspension Mount
$22900
Rode Microphones VideoMic Pro with Rycote Lyre Suspension Mount
MFR Part #: VIDEOMIC PRO-R
Samy's Part #: S-038924
Availability: In Stock
Description
Specifications
Items Included
Rate & Review
The RODE VideoMic Pro is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.
At the heart of the VideoMic Pro is an all-new 1/2" condenser capsule that provides broadcast-quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels) with an incredibly low self-noise of just 14db. A super-cardioid polar pattern ensures that surrounding audio is minimised, and your recording is focused on the subject in front of the camera.
The integrated Rycote Lyre based shock mounting system separates the VideoMic Pro capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. Constructed from a single piece of hard-wearing thermoplastic, the Lyre® provides superior acoustic suspension to traditional elastic solutions, and will never wear out, sag or snap.
Easily accessible on the rear face of the microphone are the power, filter and level controls. In addition to the microphone's native 40Hz-20kHz response a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.
Below these controls are the level settings, which attenuate or boost the recorded level as required. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. The +20dB level boost is designed for use with DSLR cameras, allowing the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry.
The microphone uses a standard sized shoe mount for on camera use, and features a 3/8" thread in the base of the mount for easy boom pole mounting. The VideoMic pro is battery powered, and provides over 70 hours recording from a single 9V battery.
The RODE VideoMic is designed and made in Australia, and covered by RODE Microphones' industry leading 10 year warranty.
Features:
- Rycote Lyreshock mounting onboard
- Capsule with lower noise and higher sensitivity
- Broadcast recording quality condenser microphone
- Compact form factor (150mm/6” length)
- Ultra lightweight (85g/3oz)
- 9V battery powered - over 70 hours use (alkaline)
- Integrated shock mounting
- Integrated foam windscreen
- 3.5mm stereo mini-jack output (dual mono)
- Two step High Pass Filter (flat, 80Hz)
- Three position level control (-10dB, 0, +20dB)
- Camera shoe mount with 3/8” thread for easy boompole mounting
- 10 year warranty with online registration.
Customers Also Browsed
-
Audio-Technica - AT897 Short Condenser Shotgun Microphone$249.00 -
Rode Microphones - NTG1 Condenser Shotgun Microphone$249.00 -
Rode Microphones - NTG-2 Battery or Phantom Powered Condenser Shotgun Microphone for Video$269.00 -
Sennheiser - MKH416-P48U3 Super-Cardioid Shotgun Tube Condenser Microphone$999.00 -
Sennheiser - MKE 400 Microphone for Video Cameras$199.95 -
-
Audio-Technica - AT875 Short Condenser Shotgun Microphone$169.00 -
-
-
Rode Microphones - NTG-3 Shotgun Microphone$699.00 -
Audio-Technica - AT8035 Line/Gradient Condenser Microphone$269.00 -
Azden - SGM-1000 Shotgun Microphone$79.00
| Microphone Information | |
| Transducer | Line Gradient Condenser |
| Polar Pattern | Supercardioid |
| Frequency Response | 40 Hz - 20 kHz (selectable HPF @80 Hz) |
| Dynamic Range | 120 dB (as per IEC 651) |
| Signaltonoise Ratio | 80 dB |
| Maximum Input Sound Level | 134 dB (@ 1 kHz, 1% THD into 1 kOhms load) |
| Impedance | 200 ohms |
| Output Connectors | 1 x 1/8" (3.5 mm) stereo mini-jack (dual mono) |
| Battery Type | 1 x 9 V alkaline battery (current 7.8 mA) |
| Low Frequency Rolloff | 80 Hz High Pass Filter |
| Low Cut Filter | Two-step (flat, 80 Hz) |
| Dimensions | 2.95 x 3.93 x 6.69" (75 x 100 x 170 mm) |
| Weight | 3 oz (85g) |
- Limited 10-Year Warranty (Online Registration Required)
See any errors? Let us know.
CALL US TOLL FREE AT 1-800-321-4726 FOR CUSTOMER SERVICE & ORDERING.
Copyright © 2021 Samy's Camera All rights reserved. Terms & Conditions | Privacy & Security Policy
Price, images, specifications and descriptions of items are subject to change without notice. We are not responsible for typographical or photographical errors. Rebates & conditions, and expiration dates from manufacturers are subject to their authorization.
POWERED BY NOX ENTERPRISE COMMERCE